Configure PRTG connection | Multi-Platform Probe for PRTG

Multi-Platform Probe for PRTG

Configure PRTG connection

Finally, finish the multi-platform probe setup in the PRTG web interface and start the multi-platform probe.

i_round_redThe PRTG core server restarts after you complete this step. During the restart, all users of the PRTG web interface, PRTG MultiBoard, or the PRTG Apps for Mobile Network Monitoring are disconnected and reconnected.

Enter the access token in PRTG

1.In the PRTG web interface, navigate to Setup | System Administration | Probes.

2.In Probe Connection Settings, make sure that Probe Connection IP Addresses is set to All IP address available on this computer or Specify IP addresses.

3.In Multi-Platform Probes, add the access token from the configuration wizard to the Access Tokens list.
i_round_blueThe access token follows the format probe ID:public key.

4.Click Save.

5.Click OK to restart the PRTG core server and apply your settings.

Approve the multi-platform probe

1.In the PRTG web interface, click Approve to include the new probe in your device tree.
i_round_redDo not click Approve and auto-discover. The multi-platform probe only supports limited auto-discovery.

i_round_blueIf you delete a multi-platform probe and want to restore it, or if you accidentally click Deny on the PRTG web instance, you must restart the multi-platform probe:

sudo systemctl restart prtg.mpprobe.service

Make sure the multi-platform probe you want to restore is not on the Deny GIDs list found under Setup | System Administration | Probes | Probe Connection Settings.