Reconfigure a multi-platform probe | Multi-Platform Probe for PRTG

Multi-Platform Probe for PRTG

Reconfigure a multi-platform probe

To change the settings of a multi-platform probe, run the configuration wizard again.

1.Run the configuration wizard:

sudo probe-admin-tool wizard

i_round_blueThe wizard offers your current settings as defaults and asks about every setting that it covers. A blank answer keeps the current setting.

2.Optionally, validate the new configuration:

sudo probe-admin-tool check

3.Restart the multi-platform probe service to apply your changes:

sudo systemctl restart prtg.mpprobe.service

i_round_redIf you generate a new identity key, you must replace the existing access token in the PRTG web interface with the new access token. Change the access token in Setup | System Administration | Probes | Multi-Platform Probes | Access Tokens. The probe ID and the monitoring history do not change when you create a new access token.

Edit the configuration file

You can also customize the multi-platform probe through the configuration file manually: /etc/paessler/mpprobe/prtg-probe.toml.

You can see a documented template of every setting with their defaults:

probe-admin-tool config-template

i_round_redThe multi-platform probe rejects unknown settings and does not start with an invalid configuration file. We recommend that you run sudo probe-admin-tool check if you edit the file by hand.