“The page below is from the manual of PRTG, our quick-to-install and easy-to-use network monitoring software”

Aurelio, System Admin at Paessler AG

The Enterprise Console has a tab-like interface. Using the tabs you can navigate through various pages with information about your monitored objects, such as your network's status, monitoring results, etc., as well as access maps, reports, and settings.

Enterprise Console Menu Tabs BarEnterprise Console Menu Tabs Bar

There is documentation available for the following tabs:

Viewing lists of sensors is a great way to keep an eye on your network's status, as you can select which kind of sensors you would like to see. You can filter by object, sensor type, and current sensor state.

Sensors Menu Tab

Note: For technical reasons, this function is available for one server at a time only. If you have configured more than one PRTG core server, please choose one server from the server list in the upper right corner.

Click on the Sensors entry in the menu tabs bar to show a table list of all sensors. You can enable a filter to only show certain sensors. To do so, choose from three different drop down menus to build a filter. With each filter you can further decrease the number of sensors shown.

  • By Type
    The second drop down menu shows all sensor types available in your monitoring setup. Select an entry to only show sensors of this type. The default value is All Types .
  • By State
    The third drop down menu shows all possible sensor states. Select an entry to only show sensors that currently show this status. Choose between All States , Down , Down (Acknowledged) , Down (Partial) , Warning , Up , Paused , Unusual , and Unknown . The default value is All States . Note: If you click on a sensor symbol in the page header bar, you can directly view a sensor list filtered by the selected sensor state for the selected server.

If you have filtered out all sensors and the list below shows no entries, try removing some filters by reverting them to the default values. To disable all filters, remove the check mark in front of the Filter by option at the beginning of the line.

In the list, one hundred entries are shown at a time. Use the arrow symbols above the list to show other items. You can jump to the beginning of the list, or browse through it hundred by hundred. If the list has more than one entry, you can also sort the items by the contents of a certain column. To sort, simply click once or twice on the header of the column you want to sort by.

From this list view, you can select multiple items in order to apply the same action to them, for example, Edit | Check Now .

You can select multiple items by the following means (you can also combine them):

  • Click and hold your left mouse key while hovering the lines you want to select
  • Hold the Ctrl key while clicking to toggle the selection status of a single line
  • Click a line and hold the Shift key while clicking another line to select all lines in between.
     

 

Copyright © 1998 - 2014 Paessler AG