"The page below is from the manual of PRTG, our quick-to-install and easy-to-use network monitoring software"
Try PRTG now and see how it can make your job easier.
PRTG Manual: PRTG Status—Cluster Status
To view the status of your PRTG installation, select Setup | PRTG Status from main menu. Click on the tabs to change the different settings.
You can view the following aspects of the PRTG status:
Click on the Cluster Status tab to view all nodes connected to the cluster. This tab is only available if you're running PRTG in cluster mode. Following information is shown:
- Cluster Status with all connected nodes as table and graphic
- Cluster Log with all log entries concerning cluster connections
Click on the Start Maintenance Mode link to put a cluster node in maintenance mode. A node in this mode is still connected to the cluster, but its monitoring results are discarded until you click on the Stop Maintenance Mode link. You can use this functionality to explicitly exclude a node from monitoring if you know that the monitoring values will not be accurate, for example, because you're reconfiguring things, etc. During maintenance, a cluster node is displayed with a transparent color in the overview graphic.
For more information about cluster settings, please see System Administration—Cluster section.