Control Panel Probes Tab

Using Local and Remote probes you can set up a multi location monitoring using IPCheck Server Monitor. See the Multi Location Monitoring Using Remote Probes section later in the manual for details.

Note: This feature is not available in the Freeware Edition!

·      Local/Remote Probe Configuration—Using the Add/Edit/Delete buttons you can edit the list of available probes that the user can select in the web interface.

·      Probe Password—Make sure to protect your remote probe by using a password which must be entered here and on the remote probe machine

·      Probe Settings For Local Machine—Using these settings you can change the settings for the Local Probe and the communication between the webserver service and probe service.

·      Local IP—This is the IP address that the local probe uses to send out the monitoring requests

·      Port—This is the TCP/IP port number that will be used by the webserver service to contact the probe service.

·      Note 1: Make sure that these ports are enabled if you run a personal firewall on this machine.