Has anyone an idea how to monitor the result of a backup made with CA Arcserve r12.5?
Thanks
Created on May 31, 2010 6:54:31 AM by
2 Replies
Please take a look at this article:
Maybe Arcserve is able to send SNMP Traps or create Windows Event Log entries that you can monitor as well.
Created on May 31, 2010 8:00:06 AM by
Last change on May 31, 2010 8:06:19 AM by
Thanks for your answer, but the problem is, that Arcserve has for every status a seperate OID. I want to know, if anybody has an idea how to monitor the state of the last Backup-Job in only one sensor.
I tried it with eventlog, but there i have the problem, that the last check-result isn't the last entry. Only the first result after an entry in the log is the notification given form Arcserve. The second check indicates "0" - so I can't see, if there was an problem with the backup.
Created on May 31, 2010 9:12:07 AM by
Please log in or register to enter your reply.
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment