What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Backup Exec eventlog message

Votes:

0

Hello,

I have a question: If the event log runs up an error should be reported in this PRTG and light up as errors.

The Backup Exec throws in a failed backup following an event log with Event ID 34113 and the message "Backup Exec: Job Failed". When this event occurs PRTG should report it as alarm.

Christian

backup-exec prtg wmi

Created on Nov 13, 2012 8:47:31 AM



1 Reply

Votes:

0

Hello,

it should be possible to do this, with setting up a WMI Eventlog Sensor just filtering for this Event with ID and message, and then setting the Upper Error Limit in the Channel Settings of the sensor to '0'. Which will set the sensor into error state as soon as it monitors such an event. However the sensor will only remain in the error state until the next scan when no such new event is found.

best regards.

Created on Nov 13, 2012 2:11:28 PM by  Torsten Lindner [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.