I have a Cisco router with a dual-stack setup. The majority of my traffic is Ipv4 but some is IPv6. I am sending all the data to PRTG via NetFlow v9. I would like to separate the traffic by IPv4 and IPv6 so that I can determine my usage stats. I thought maybe I could make a sensor for each type and then exclude the opposite protocol from that sensor. Does this sound reasonable or should I try another way? I'm a bit new to PRTG so I'm still figuring out how it all works, any insight or pointers would be greatly apprecitated.
Differentiate between IPv4 and IPv6 flows?
Votes:
0
Best Answer
Accepted Answer
Votes:
0
Update: NetFlow V9, NetFlow V9 (Custom), IPFIX, and IPFIX (Custom) sensors support IPv6 flows in PRTG version 18.2.40 or later.
Created on May 9, 2018 9:54:53 AM by
7 Replies
Votes:
0
I'm afraid PRTG's NetFlow sensors aren't IPv6 capable. Sorry.
Created on Jun 12, 2012 12:09:51 PM by
Votes:
0
Please have a look at What PRTG sensor types support IPv6?
Created on Jun 12, 2012 3:00:27 PM by
Votes:
0
So far no fixed plans for that. Sorry.
Created on Aug 17, 2012 3:54:13 PM by
Accepted Answer
Votes:
0
Update: NetFlow V9, NetFlow V9 (Custom), IPFIX, and IPFIX (Custom) sensors support IPv6 flows in PRTG version 18.2.40 or later.
Created on May 9, 2018 9:54:53 AM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment