How do I configure SSH authentication?

Votes:

0

Your Vote:

Up

Down

Hello.

How do I configure SSH authentication? Our PRTG runs on Windows 2008 R2, but we want to monitor a Linux Web server which only allows login from /etc/.ssh/known_hosts. Where do I make or get the required information to authenticate. Until now, there are two entries in /etc/.ssh/known_hosts 11.22.33.44 ssh-rsa VTZUBHTBUHNIJFTUN.... 22.33.44.55 ssh-rsa SAWERJIF....

What do I need to enter there to allow access from the PRTG-Server?

Bye

known-hosts ssh windows

Created on Jan 17, 2012 3:15:30 PM by Armin Koch (0) ●1



1 Reply

Votes:

0

Your Vote:

Up

Down

Hello.

I'm afraid this is not supported by PRTGs SSH-Sensors in the moment.

sorry.

Created on Jan 20, 2012 1:24:05 PM by Torsten Lindner [Paessler Support] (15,450) ●3 ●1



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Back to www.paessler.com

PRTG
Network Monitor
Intuitive to Use.
Easy to manage.

150.000 administrators have chosen PRTG to monitor their network. Find out how you can reduce cost, increase QoS and ease planning, as well.

Visit
www.paessler.com

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

Top Tags


View all Tags