How can I prevent data gaps in Sensor Factory sensors with NetFlow sensors?
Created on Aug 23, 2011 10:54:44 AM by
Last change on Sep 19, 2011 9:10:30 AM by
How can I prevent data gaps in Sensor Factory sensors with NetFlow sensors?
1 Reply
Accepted Answer
Because of timing issues with the arriving Netflow data the scanning interval of the Sensor Factory should be higher than the scanning interval of the Netflow sensors.
E.g. you are collecting Netflow data with an interval of 60 seconds a Sensor Factory sensor which references this Netflow sensors should be configured with a scanning interval of 2 minutes.
Sometimes a shorter interval of the Sensor Factory is possible, we tested a interval of 60 seconds in the Netflow sensors an a 70 second interval in the Sensor Factory with no resulting gaps.
Created on Sep 19, 2011 9:09:56 AM by
Please log in or register to enter your reply.
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment