What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

The PRTG downtime basics

Votes:

0

I do not understand the basics about downtime. How is downtime (for snmp interface traffic monitoring) calculated? I mean I think I get fake information for snmp sensor about downtime. PRTG requests snmp information via snmp and what should happen to show a downtime? SNMP reply with some "down" information? Or PRTG calculates no counter change since last check or something else?

basics downtime prtg

Created on May 7, 2011 4:39:32 PM



1 Reply

Votes:

0

Hello,

the calculation of downtime is the same for every sensor. Downtime is the time between at least two consecutive failed scans of a sensor (i.e. scans with the sensor going and staying in DOWN state). Then the time between these two scans (or if more, the time between the first and the last scan) is accounted as downtime.
So first of all this downtime refers to the sensor itself. Not necessarily to the target (SNMP Traffic Sensors don't get downtime information from a switch or similar).

Best regards.

Created on May 9, 2011 1:34:03 PM by  Torsten Lindner [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.