Send alarm when remote probe goes down

Votes:

0

Your Vote:

Up

Down

We have a probe on a site that sometimes goes down, and it has noting to do with the remoteprobe. There is something on the network thats playing with us. So when the remote probes is disconnected, we need to get an alarm about that. How to do it? Havent found any solution.

alarm disconnected remote-probe

Created on Apr 4, 2011 11:00:31 AM by Peter Hoas (0) ●1



1 Reply

Votes:

0

Your Vote:

Up

Down

Hello,

you would have to setup a State Trigger on the according "Probe Health"-Sensor. That should then alarm you if this probe gets disconnected.

best regards.

Created on Apr 4, 2011 1:10:46 PM by Torsten Lindner [Paessler Support] (15,450) ●3 ●1



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Back to www.paessler.com

PRTG
Network Monitor
Intuitive to Use.
Easy to manage.

150.000 administrators have chosen PRTG to monitor their network. Find out how you can reduce cost, increase QoS and ease planning, as well.

Visit
www.paessler.com

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

Top Tags


View all Tags