Which are the minimum hardware requirement for a server to install a Probe that monitor about 500 sensors?
Thanks a lot!
Gianluca
Created on Jan 24, 2011 2:14:23 PM by
1 Reply
Accepted Answer
Hello,
it is very hard to name the specific requirements without further details. Please see http://www.paessler.com/prtg/requirements Most likely every up-to-date Dual-Core PC with at least 1GB or RAM will do fine. Harddisk is not important as Remote Probes only write logfiles on disk, everything else is sent to the PRTG Core.
Best Regards.
Created on Jan 24, 2011 4:04:05 PM by
Please log in or register to enter your reply.
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment