Cluster/License issue

Votes:

0

Your Vote:

Up

Down

I am setting up a cluster with PRTG 8 and I have followed the steps in 10 Steps to Set Up a Cluster—Scenario 3: You've Set Up Two PRTG 8 Installations Already. However, upon trying to access the web interface on the fail over node I receive and error. System emergency. the system was halted, because of the following: The license of this cluster member is not valid for operating in the configured cluster. Now my company has the 100 sensor license. The master node states that the fail over node needs to be activated. I am not sure exactly what is going wrong or where. Best regards - john

cluster license system-emergency

Created on Jan 6, 2011 12:14:36 AM by John Kuhling (0) ●1



1 Reply

Votes:

0

Your Vote:

Up

Down

Hallo,

please send the Logs(System) folder from both the master and failover note to

support @paessler, com

Created on Jan 7, 2011 6:48:45 AM by Aurelio Lombardi [Paessler Support] (7,239) ●3 ●1



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Back to www.paessler.com

PRTG
Network Monitor
Intuitive to Use.
Easy to manage.

150.000 administrators have chosen PRTG to monitor their network. Find out how you can reduce cost, increase QoS and ease planning, as well.

Visit
www.paessler.com

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

Top Tags


View all Tags