Telnet login using windows GUI tool

Votes:

0

Your Vote:

Up

Down

I was able to set a command shortcut to telnet a device

command:telnet parameters: %host

This will simply telnet the device and wait for login.

how can i make it automatically send further login parameters:

ex (cisco router):"username">"pass">enable>"enable pass".......

I have several routers and all of them have the same login credentials so this would be helpful.

gui login telnet

Created on Oct 12, 2010 6:06:59 AM by Mike Tayeh (0) ●1

Last change on Oct 12, 2010 8:31:57 AM by Daniel Zobel [Paessler Support] (21,383) ●3 ●3



1 Reply

Accepted Answer

Votes:

0

Your Vote:

Up

Down

Dear Mike,

from the WinGUI there are no other placeholders available than (%id, %name, %host, %message, %type). So it is not possible to get the login information (credentials) from the device-settings in PRTG.

Best Regards.

Created on Oct 13, 2010 1:02:26 PM by Torsten Lindner [Paessler Support] (15,450) ●3 ●1



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Back to www.paessler.com

PRTG
Network Monitor
Intuitive to Use.
Easy to manage.

150.000 administrators have chosen PRTG to monitor their network. Find out how you can reduce cost, increase QoS and ease planning, as well.

Visit
www.paessler.com

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

Top Tags


View all Tags