In order to provide graphs that show a quick status overview of your complete network (or a part of it) PRTG computes so-called "index" values based on the measurements of all sensors. The "index" graphs are synthetic values between 0% and 100% based on current sensor measurements and their historic maximum values. The calculation of these index values works similar to a stock index which is computed using the current values of selected stocks. For each group and device PRTG shows four values in a graph. screenshot

They are based on the measurements of all sensors in that group (or device). The "Alarms" graph simply shows the number of alarms at a given moment in history. Then there are three index values:

  • "Response Time Index"
  • "CPU Load Index"
  • "Traffic Index"

Examples

A CPU Load Index value of 10% for a group means that the average CPU load for all CPU sensors of this group currently is at 10% of the highest ever measured CPU usage value of that group. For response times usually the historic maximums are much higher than the average value. E.g. for pings in a LAN a "normal" time might be 2-10ms while a maximum of several hundred Milliseconds is not unusual. This is the reason that most Response Time Index readings are usually between 10% and 20%. The following two charts show the traffic index for two switches for 48 hours: screenshot The upper graph shows the traffic of one of our workstations switches. During the night the graph shows a flat zero line - nobody was in the office. The lower graph shows the traffic of our core network switch. It has been busy all day and night because we run a lot of backup tasks during the night.

How does it work?

  • During the normal network monitoring process PRTG records the highest value ever measured for each sensor
  • The current measured value is weighted with this boundary values to compute an index value for a sensor between 0% and 100%
  • For each device the index values for CPU load sensors, traffic sensors and sensors that measure response times are combined
  • For each groups the index values of all devices are combined
Keep in mind that changing the sensor setup (i.e. the number and types of sensors) will also inevitably change the index values because the numerical base for the calculation changes. This means that value before and after a configuration change may not be comparable at all. The same applies to situations where one or more sensors can not be monitored (e.g. when a probe is disconnected).


Copyright © 1998 - 2011 Paessler AG
Solutions • Contact • Sitemap • Privacy Policy • Terms